Deck Stair Calculator

Units

Deck surface to the ground or landing, measured plumb.

36 in minimum.

Tread depth, riser face to riser face. 10 in minimum.

Two 5.5-inch boards make an 11-inch tread.

Actual thickness of the tread boards: 1.5 in for 2× lumber.

Your materials

Results update as you type.

Risers
5 risers
7.2 in (≈ 7 3/16 in) each
Total run
3 ft 4 in
Within the 6 ft stringer span
Stringers
3 stringers
2 × 12, 4 ft 6 in long

How it adds up

  1. Risers 5 risers

    36 in rise ÷ 7.75 in maximum = 4.65, rounded up to 5 36 in ÷ 5 = 7.2 in (≈ 7 3/16 in) per riser

  2. Treads 4 treads

    5 risers − 1 = 4: the deck itself is the top step

  3. Total run 3 ft 4 in

    4 treads × 10 in = 3 ft 4 in DCA 6 Figure 28 allows a cut stringer to span 6 ft

  4. Stringers 3 stringers

    Cut stringers at most 18 in apart across 36 in, and never fewer than 3 = 3 Length: √(36 in² + 40 in²) = 4 ft 5.81 in, so 4 ft 6 in of stock before any extra for the top and bottom cuts

  5. Stringer layout 35.8° pitch

    Each notch: 7.2 in (≈ 7 3/16 in) rise by 10 in run Pitch: tan⁻¹(7.2 in ÷ 10 in) = 35.8° Bottom cut: 7.2 in riser − 1.5 in tread = 5.7 in (≈ 5 11/16 in), so the first step finishes as tall as the rest

  6. Tread boards 8 boards

    4 treads × 2 boards = 8 8 × 3 ft = 24 ft

  7. Tread fasteners 24 screws

    4 treads × 3 stringers × 2 #8 screws or 8d nails = 24

  8. Code checks Pass

    Run of 10 in meets the 10 in minimum. Width of 36 in meets the 36 in minimum. A stair guard is required: the rise is 30 in or more. A handrail is required on at least one side: 4 or more risers.

Estimates only. Results come from the formulas on the full page and use no outside data. Check local building codes and your supplier before buying.

Free calculator by DeckTally, with the formulas, sources and FAQ on the full page.